Full system diagnostic
We test the thermostat, igniter, blower motor, and safety controls. On heat pumps we check refrigerant pressures with manifold gauges. You get a clear explanation of what failed and why.
Same-day furnace and heat pump fixes from licensed techs
Heating repair Milwaukie OR you can count on
When your furnace quits on a cold Milwaukie night, you need heating repair Milwaukie OR fast. Our NATE-certified techs diagnose and fix gas furnaces, heat pumps, and electric heaters across Clackamas County. We stock common parts like capacitors and blower motors, so most repairs finish in one visit. Call (855) 947-9500 for same-day service.
Careful work. Honest options.
About this service
What heating repair Milwaukie OR actually involves
Heating repair Milwaukie OR means finding out why your furnace, heat pump, or electric heater stopped working and fixing it correctly. A proper repair starts with a full diagnostic: we test the thermostat, check the igniter or pilot, measure refrigerant pressures on heat pumps, and inspect the blower motor and capacitor. We use a multimeter and clamp meter to trace electrical faults, and a leak detector to find refrigerant leaks. If your furnace is not heating, the problem is usually a dirty air filter, failed igniter, or a clogged condensate drain. We fix the root cause, not just the symptom.
Milwaukie homes deal with wet, cold winters and older ductwork that leaks heat into crawlspaces. That is why so many calls start with 'my heater is running but the house stays cold.' If you search for heating repair near me Milwaukie OR, you want a tech who knows local building stock, from 1920s bungalows near Kellogg Creek to newer builds in Milwaukie Heights. We see ignition failures after summer humidity, and frozen heat pump coils in January. We also handle emergency heating repair near me Milwaukie calls when a furnace dies overnight.
- ✓ Same-day heat repair
- ✓ Upfront, honest pricing
- ✓ Licensed and code-correct
- ✓ Emergency service, 24/7
What's included
What our heating repair service includes
Every heating repair Milwaukie OR visit includes a full diagnostic, a flat price before work begins, and a written warranty on the repair. Here is what is covered and what we can add on if needed.
Flat-rate repair pricing
You approve a flat price before we start. No hourly surprises. Most heating repair Milwaukie OR jobs run $180 to $650 in 2026, including parts and labor.
Common parts on the truck
We stock capacitors, contactors, igniters, blower motors, and R-410A refrigerant. That means most repairs finish in one visit, not two or three.
Safety and code checks
After any furnace repair we test gas pressure, flue draft, and carbon monoxide levels. We follow ACCA and ASHRAE standards. Your system leaves code-correct.
Written warranty
Every repair comes with a written workmanship warranty. If the same part fails within the warranty period, we return and fix it at no charge.
How it works
How our heating repair process works
You call (855) 947-9500 or book online. A dispatcher asks what your heater is doing, confirms your address in Milwaukie, and gives you a two-hour arrival window. Most calls get same-day slots. You get a text when the tech is on the way.
The tech arrives, puts on shoe covers, and runs a complete diagnostic. That means testing the thermostat, checking voltage at the igniter and blower motor with a multimeter, and reading refrigerant pressures on heat pumps with manifold gauges. Takes 20 to 40 minutes.
We show you what failed, explain the repair in plain language, and give you a flat price before we touch a wrench. You decide. If you want a second opinion, that is fine. No pressure, no hidden fees. Most homeowners approve on the spot.
We replace the bad part, whether that is a capacitor, contactor, igniter, or blower motor. Then we run the system through a full heating cycle, check temperature rise at the vents, and verify gas pressure and flue draft. You see the numbers before we pack up.
We haul away the old part, wipe down the work area, and hand you a written warranty on the repair. You also get a maintenance tip sheet. If the same issue comes back within the warranty window, we return at no charge.
STEP 01Call and book
You call (855) 947-9500 or book online. A dispatcher asks what your heater is doing, confirms your address in Milwaukie, and gives you a two-hour arrival window. Most calls get same-day slots. You get a text when the tech is on the way.
Tools & methods
Tools and methods we use
Manifold gauges
Used on heat pumps to read refrigerant pressures and diagnose leaks or undercharge. Accurate readings prevent misdiagnosis and wasted refrigerant.
Multimeter and clamp meter
We trace electrical faults at the igniter, blower motor, and control board. A clamp meter reads amp draw to confirm a failing motor.
Leak detector
Finds refrigerant leaks on heat pump lines and coils. Early detection saves refrigerant and prevents compressor damage.
Vacuum pump and recovery machine
We recover old refrigerant per EPA 608 rules and pull a deep vacuum before recharging. This protects the system and the environment.
Fin comb and duct cleaning vacuum
We straighten bent condenser fins and clean ductwork to restore airflow. Better airflow means lower heating bills.
Real results
Before and after.
heating repair
No-heat furnace in Downtown Milwaukie
A homeowner called at 7 a.m. after waking up to a 58-degree house. The furnace clicked but never fired. The igniter was visibly cracked and the air filter was clogged with dust.
After: We replaced the igniter, installed a new filter, and tested the heating cycle. Temperature rise at the vents hit the manufacturer spec. The house reached 70 degrees in 45 minutes.
Book this service →
heating repair
Frozen heat pump in Milwaukie Heights
A heat pump ran constantly but blew cold air. Ice covered the outdoor coil. The defrost board had failed, so the system never entered defrost mode. Refrigerant charge was also low.
After: We replaced the defrost board, found and repaired a refrigerant leak, and recharged with R-410A. The system held pressure and cycled normally. The house warmed to setpoint within two hours.
Book this service →
heating repair
High bills in Oak Grove
A homeowner's heating bill jumped $80 in one month. The blower motor was drawing high amps and the ductwork had visible leaks at several joints. Airflow was weak at the far vents.
After: We replaced the blower motor, sealed accessible duct leaks with sheet metal and fiberglass insulation, and balanced airflow. The next bill dropped by $45.
Book this service → Problems we solve
Common heating problems we solve in Milwaukie
Milwaukie heaters fail in predictable ways. Wet winters, older ductwork, and temperature swings take a toll. Here are the problems we fix most often for heating repair near me Milwaukie OR customers.
Ask a pro →Furnace not heating at all
We diagnose the igniter, flame sensor, and limit switch. Most no-heat calls trace to a failed igniter or a tripped safety. We replace the part and test the full heating cycle before we leave.
Heat pump frozen or blowing cold
We check the defrost board, reversing valve, and refrigerant charge. A leak or a bad defrost sensor is usually the cause. We repair the leak, recharge with R-410A, and verify the defrost cycle.
Thermostat malfunction
We test the thermostat wiring and calibration. If it is a Nest or Ecobee, we check the app settings and C-wire. A bad thermostat gets replaced and programmed to your schedule.
Blower motor failure
We test the blower motor with a multimeter and clamp meter. A failed capacitor or motor gets replaced. We also check the air filter and ductwork for restrictions that shorten motor life.
Proof you can check
Licensed, certified, and reviewed
- NATE Certification · North American Technician Excellence
- EPA Section 608 · U.S. Environmental Protection Agency
- Oregon CCB License · Oregon Construction Contractors Board
- OSHA Safety Compliance · Occupational Safety and Health Administration
Most heating repair Milwaukie OR jobs run $180 to $650 in 2026, depending on the part and labor. A capacitor or igniter replacement sits at the low end. A blower motor or refrigerant leak repair costs more. We give you a flat price before we start, so you never get a surprise bill.
ThermexaPro repairs gas furnaces, electric heaters, and heat pumps in Milwaukie, Oregon. We are NATE-certified, EPA 608 certified, and Oregon CCB licensed. Call (855) 947-9500 and we will dispatch a tech to your address in Milwaukie or nearby Clackamas County neighborhoods.
Yes. We offer 24/7 emergency heating repair near me Milwaukie service. If your furnace dies overnight or on a weekend, call (855) 947-9500. A dispatcher answers, and we roll a truck with common parts on board. Most emergency calls get a tech at the door within a few hours.
The most common causes we find in Milwaukie are a dirty air filter, a failed igniter, a tripped limit switch, or a thermostat malfunction. Heat pumps can freeze over in winter. If your furnace not heating repair Milwaukie OR call comes in, we diagnose the root cause and fix it, usually the same day.
Ready when you are
Get heating repair Milwaukie OR today
Do not wait for the house to get cold. Call (855) 947-9500 now for same-day heating repair Milwaukie OR service. Licensed, insured, and warrantied. We answer 24/7.
Book a repair (855) 947-9500 →
Request an appointment
Contact ThermexaPro in Milwaukie
Call (855) 947-9500 any time, day or night, and a live dispatcher will get a tech headed your way. Regular office hours run 8 a.m. to 6 p.m. Monday through Friday, with 24/7 emergency coverage for no-heat and no-cool calls. You can also email [email protected] and we will reply the same business day.
Call anytime(855) 947-9500Email the office[email protected]
Office hoursOpen 24 hours · 7 days a week